To perform a Factory Reset on a Flame Boss® FB200v2 and FB300 controllers follow these steps:


1. Plug in power supply to turn on controller

2. Press and hold the ‘Menu’ and the 'Up' arrow button (^) at the same time on the controller until a long ‘chirp’ is heard. The following is displayed:

    [Main                ]

     Temp Control

3. Press 'Up' button 3 times until the following is displayed:

    [Other               ]

     Manual Mode

4. Press 'Menu' button 1 time and the following is displayed:

    Factory Reset

    Push Up 3 Times

5. Press 'Up' button 3 times and the controller will briefly display the current firmware version then the controller's main screen. The controller has been reset to factory default settings.


NOTE: Performing a factory reset deletes any saved WiFi settings you have entered previously. You will have to perform the WiFi setup process again after doing a factory reset in order for your controller to connect to your WiFi


To perform a Factory Reset on a Flame Boss® FB200 controller, follow these steps:


1. Plug in power supply to turn on controller

2. Press the 'Menu' button several times until the following is displayed:

    Other Menu

    [Skip]

3. Press the 'Up' arrow button to switch [Skip] to [Enter] and then press the 'Menu' button

4. Press the 'Menu' button several times until the following is displayed:

    Factory Reset

    Push Up 3 Times

5. Press 'Up' button 3 times and the controller will briefly display the current firmware version then display the controller's main screen. The controller has been reset to factory default settings.


NOTE: Performing a factory reset deletes any saved WiFi settings you have entered previously. You will have to perform the WiFi setup process again after doing a factory reset in order for your controller to connect to your WiFi


To perform a Factory Reset on a Flame Boss® FB400 or Big Green Egg® EGG Genius, follow these steps:


1. Plug in power supply to turn on controller

2. Using a paperclip or similar device, insert it into the small hole on the bottom of the controller located between the pit and meat jacks

3. Press and hold for 5 seconds and then release. The controller will reset to factory default settings. 

    TIP: To switch the FB400 or EGG Genius from 'Station' to "Access Point' mode, press and hold for 1 second and then release. Holding longer may perform a Factory Reset after 5 seconds.


NOTE: Performing a factory reset deletes any saved WiFi settings you have entered previously. You will have to perform the WiFi setup process again after doing a factory reset in order for your controller to connect to your WiFi


If you need further assistance, please click here to Contact Us or call us at 800-978-9078.